![]() ![]() The delay figure for the acoustic timing reference always uses the estimated IR delay/estimated IR start. Added an Analysis preference to choose whether the System delay figure for loopback measurements is based on the relative timing of the measured and loopback IR peaks (the default) or either the estimated IR delay relative to the loopback when the peak is close to the IR start or the estimated IR start time relative to the loopback when the peak is later (limited bandwidth devices).Added Burst Decay modes to the waterfall and spectrogram.Bug fix: TS params calculated QMS figure was too high and RMS figure was too low. ![]() Bug fix: Long comments could push buttons out of view on room sim image capture dialog.Widened tolerance for channel gain mismatch on impedance open circuit calibration to 2 dB and added help text on how to balance channel gains.Added the current sample rate in the RTA window title.Added a dB Average button in the All SPL graph controls that averages the dB values of the selected traces.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |